We are able to remove dents from cans, but one of our customers decided to truly challenge us with this crushed can. After quite a bit of work we were able to turn this back into a beer can. Who would think we could do this or that you could hardly tell?
This is a short sheet which means the sheet was not wide enough to properly seam the can. A seam from another beer can was inserted so the sheet could be rolled to the correct diameter. Below is the finished can after the top and bottom were applied.
We turned this drinking cup into a flat top beer can. The cup had a handle attached to the seam and a rolled lip. To convert the mug back into a beer can we had to unroll the lip, remove the handle/solder and finish it off with a nicely matched donor lid.